Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
Text excerpt from page 18 (click to view)
Caring For Your Dryer
In This Section Page
load ............................. 18 Malntenanc~o
Page
needed ...... ... .................. 19
Malntenance+every
I
Dryers require regular maintenance. Follow the suggestions below to maintain your dryer properly.
Maintenance-every
Cleaning the lint screen
load I
Product and Fabric Damage Hazard Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so can cause overheating and damage to both the dryer and fabrics.
The lint screen is located under a lid on top of the dryer. Clean lt before each load. A screen blocked by lint can increase drying time.
1. Open the lid and pull the lint screen straight out.
2. Roll lint off the screen with your fingers. Do not rinse or wash the screen to remove lint. Wet lint is hard to remove. 3. Push the lint screen firmly back into place and close the lid.
Lint
signal
(on some models)
Restricted airflow reduces drying efficiency. The signal (a whistle tone) lets you know if the airflow is restricted. l Turn off the dryer and clean the lint screen. NOTE: Clean your lint screen before each load. Do not wait for the lint signal. The lint signal indicates excessive lint present on your lint screen. If you wait for the lint signal before you clean the lint screen, drying efficiency will be reduced.
