Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
Text excerpt from page 7 (click to view)
3.
REPLACING THE BATTERIES
1. Loosen the screw on the back of the SF-5300B that holds the battery compartment cover in place, and remove the cover. Loosen the screw that secures one of the two battery holders in place and remove the battery holder. Caution:Be sure to remove only one battery at a time. Otherwise, you will lose all data stored in memory. 3. Replace the old battery with a new one. Be sure that the positive (+) side of the new battery is facing up (so you can see it).
Screw
RESET
2.
4.
Replace the battery holder and secure it by tightening its screw. � Be careful that you do not overtighten the screw. Repeat Steps 2 through 4 for the other battery. � Be sure to replace both batteries. Never mix old batteries with new ones, and be sure to use CR2032 lithium batteries only. After you replace both batteries, replace the battery compartment cover and secure it by tightening its screw. � Be careful that you do not overtighten the screw.
