|
|
|
Who's Online
There currently are 5744 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
3.
REPLACING THE BATTERIES
1. Loosen the screw on the back of the SF-5300B that holds the battery compartment cover in place, and remove the cover. Loosen the screw that secures one of the two battery holders in place and remove the battery holder. Caution:Be sure to remove only one battery at a time. Otherwise, you will lose all data stored in memory. 3. Replace the old battery with a new one. Be sure that the positive (+) side of the new battery is facing up (so you can see it).
Screw
2.
RESET
4.
Replace the battery holder and secure it by tightening its screw. � Be careful that you do not overtighten the screw. Repeat Steps 2 through 4 for the other battery. � Be sure to replace both batteries. Never mix old batteries with new ones, and be sure to use CR2032 lithium batteries only. After you replace both batteries, replace the battery compartment cover and secure it by tightening its screw. � Be careful that you do not overtighten the screw.
5.
6.
�6�
|
|
|
> |
|
