This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
It was easy done, and I got exactly what I was looking for.
Text excerpt from page 21 (click to view)
Troubleshooting
RADIO RECEPTION Radio reception is poor. � If the signal is too weak, adjust the antenna or connect an external antenna for better reception. � Increase the distance between the Micro HiFi System and your TV or VCR.
TAPE OPERATION / RECORDING Recording or playback cannot be made. �CHECK TAPE� is displayed. The tape deck door cannot open.
� Clean deck parts, see �Maintenance�. � Use only normal (IEC I) tape for recording. � Apply a piece of adhesive tape over the missing tab space. � Remove and reconnect the AC power plug and switch on the system again.
GENERAL The system does not react when buttons are pressed. Sound cannot be heard or is of poor quality.
The left and right sound outputs are reversed. The remote control does not function properly.
� Remove and reconnect the AC power plug and switch on the system again. � Adjust the volume. � Disconnect the headphones. � Check that the speakers are connected correctly. � Check if the stripped speaker wire is clamped. � Check the speaker connections and location. � Select the source (CD or TUNER, for example) before pressing the function button ( , , ). � Reduce the distance between the remote control and the system. � Insert the battery with its polarities (+/� signs) aligned as indicated. � Replace the battery. � Point the remote control directly toward IR sensor on the front of the system. � Set the clock correctly. � Press TIMER ON / OFF to switch on the timer. � If a recording is in progress, stop the recording. � Power has been interrupted or the power cord has been disconnected. Reset the clock/timer.
