The manual is complete with excellent quality! One suggestion, show number of pages and weather it is multi-lingual. The AD 600 Manuel is about 76 pages and over half is non English. This results in a larger print job than usually needed. Having this information, one could select the desired pages for printing.
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
Text excerpt from page 15 (click to view)
Preparation
Using the remote control
IMPORTANT! � Remove the protective plastic tab before using the remote control. � Always point the remote control directly towards IR area on the Center or Station you wish to operate. Notes for remote control: � First select the source you wish to control by pressing one of the source select keys on the remote control (for example CD,TUNER). � Then select the desired function (for example ��, à ë). , To replace the remote controls� battery
Setting the clock
After connecting MCM239D to the power supply, set the clock first.
1 Press and hold STANDBY-ON/ ECO
POWER to switch the set to Standby mode. � The display shows the set time. � -- --:-- -- flashes by default if you have not set the clock. In the standby mode, press and hold DISPLAY/ CLOCK. � SET CLOCK scrolls on the display � 24 HR or 12 HR appears for the initial clock setting. To select 24-hour clock or 12-hour clock, a. Press VOLUME +/- . b. Press DISPLAY/CLOCK to confirm � The hours digits start flashing Hold down or press VOLUME +/- repeatedly to set the hours. Press DISPLAY/CLOCK to confirm � The minutes digits start flashing Hold down or press VOLUME +/- repeatedly to set the minutes. Press DISPLAY/CLOCK to confirm � To exit without storing the clock setting press STOP 9 Helpful hints: � The clock setting will be erased when the system is disconnected from the power supply. � The set will exit from the clock setting mode if no button is pressed within 90 seconds. � To set the clock automatically by using a time signal which is broadcast together with the RDS signal see chapter RDS: Setting the RDS clock..
2
3 4 5 6
1 2 3
Push to open the battery tray. Replace a new battery according to the indicated polarity. Push the battery tray back to close it.
CAUTION! � Remove the battery if it is exhausted or will not be used for a long time. � Batteries contain chemical substances, so they should be disposed of properly.