WHIRLPOOL MDB5010AWW
Owner's Manual

Disconnecting
[] D

a Convertible
removing the connector.

Be sure to turn the water supply off and press the pressure release button BEFORE Press down on the thumb release and remove the connector from the faucet.

1_1 Push the connector and hoses back into the cabinet recess. t_ Unplug the electrical cord and push it back into the cabinet recess.

Water

Conditions

..................................................

Hard Water contains minerals that can cause a film or deposit on the dishwasher tub and dishes. You may first
notice this as "cloudy" glasses. To confirm if the film is due to hard water, soak a glass for approximately 5 minutes in undiluted white vinegar. Rinse and dry. If the film is removed, it is due to hard water (if not removed, see Soft Water). To correct: To remove film from the dishwasher: 1. Adjust the detergent amount to the degree of water hardness. (See pg. 6) 2. Check the water temperature. (See pg. 6) 3. Use a rinse aid to improve the sheeting action of the water. (See pg. 7) (To' one of the following.) 1. A damp cloth and mild scouring powder. 2. A half-cup white vinegar in a Normal cycle with

detergent in the MAIN WASH cup only.

Soft Water can promote etching if too much detergent is used, items are prerinsed or the water temperature is too high. Etching is a permanent pitting or eroding of the surface of the glassware. The beginning stages can be identified by a "rainbow" effect-- shades of blue, purple, brown or pink when the glass is held at an angle to the light. In advanced stages the surface appears frosted, spotted or cloudy. Etching can happen in any dishwasher and there is no relationship to the cost or quality of the glass. Rust Minerals To prevent: 1. Adjust the detergent amount to water hardness. (See pg. 6) 2. Adjust the water temperature. (See pg. 6) 3. Do not prerinse. This aggravates etching.

(iron and manganese) can turn dishes or the tub interior a brown, red or black color. To remove: (Do not use this method on metal items.) 1. Use a rust removing compound like RoVer Rust Remover* (available from an authorized Maytag Parts Retailer by using Part No. 57961). Do not use RoVer with dishwashing detergent. 2. Fill both detergent cups with RoVer. Complete a Normal wash cycle. Follow with a short wash cycle using dishwasher detergent. 3. The only permanent solution is to install special filters which can remove iron and manganese from the water. 10

To prevent: 1. Drain your home's water heater once a year to flush away any mineral deposits. 2. Check with a water treatment company like Culligan or Kinetico to see if a filter is needed in the home.