Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
Text excerpt from page 8 (click to view)
Recording to MDs
Recording to an MD
If the MD has been partially recorded, recording starts after the recorded tracks.
To change the display while recording
Press LEVEL/DISPLAY/CHAR (or DISPLAY) repeatedly to change the display. Each time you press the button, the display changes cyclically as follows: Track number and recorded time of the current track t Remaining recordable time2) on the MD t Level of the input signal t Track name3)
2) Time shown in the display differs depending on the setting of REC MODE. 3) �No Name� appears when the track has no name.
1 Turn on the amplifier and program
source, and select the source on the amplifier.
2 Press ?/1 to turn on the deck.
The STANDBY indicator turns off.
3 Load a recordable MD into the slot
(page 15).
4 Press INPUT repeatedly to select the
input jacks (connector) connected to the program source. When the source is connected to the DIGITAL OPTICAL IN connector ANALOG IN jacks Set INPUT to
Notes on recording
After recording
D-IN A-IN
5 Press REC z.
The deck changes to recording pause.
Press EJECT A to remove the MD or press ?/1 to turn off the deck. �TOC� or �TOC Writing� starts flashing. The TOC is updated and recording is completed.
Before disconnecting the AC power cord
6 Adjust the recording level if necessary.
For details, see �Adjusting the recording level� on page 12. Recording starts.
7 Press H or X. 8 Start playing the program source.
Operations you may want to do during recording To Stop recording Pause recording Resume recording after pausing1) Eject the MD Press x X H or X EJECT A after stopping recording
MD recording is completed when the MD Table of Contents (TOC) is updated. The TOC is updated when you eject the MD or press ?/1 to turn off the deck. Do not disconnect the AC power cord before updating the TOC (while �TOC� is lit) or while updating the TOC (while �TOC Writing� is flashing) to ensure a complete recording.
Automatic conversion of digital sampling rates
A built-in sampling rate converter automatically converts the sampling frequency of various digital sources to the 44.1 kHz sampling rate of the MD deck. This allows you to monitor and record sources such as 32 or 48 kHz DAT tape or satellite broadcasts, as well as the CDs and MDs.