Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
SV121 HV61 HV51 MV21 MV16
Automatic SP/LP selection A: If, at the beginning of a timer programme, there is not enough tape left to complete it, the SP/LP function will automatically run the tape at LP speed. This ensures that the entire programme will be recorded. If the LP mode is not enough to �stretch� the remaining tape to fit, you will not be able to record all of the TV programmes. D It is not possible to automatically activate the EP mode.
Press PROG/CHECK, the Timer recording menu appears. Press PROG/CHECK again or EXIT to quit the menu.
!
Changing or cancelling a timer programme
!
Press PROG/CHECK, the Timer recording menu appears. With select the entry you would like to edit, confirm with ENTER. Modify entries with and confirm with ENTER. Press RESET/CANCEL to delete a recording.
SV121 HV61 HV51 MV21 MV16
VPS/PDC function If a TV programme begins or ends earlier or later than planned, this function synchronises the beginning and end of the recording session with the actual beginning and end of the TV programme through a VPS signal transmitted by the TV station. ON : The station transmits VPS/PDC signals. You must set the timer to the time specified in the TV magazines. Use the special VPS time the TV magazine may indicate. - - - : The station does not transmit VPS/PDC signals. Try to set the start and stop time such that the entire film can be recorded even if a programme begins or ends earlier or later than planned.
! ! !
Playing back programmed recordings
!
Press PROG PLAY. The device will rewind to the beginning of the recording, and automatically start playing it back.
