Thank you for your shop manual! Your help was very useful - the device is repaired! Once again - Thank you! I wish you a successful business! Edward (Russia).
It was a great experience,instead of purchasing a new Stereo Amplifier ,in just minutes i repaired my old one and that was thaks to the manual I have purchased from you.
Thanks again.
Samuel Alter
Das ging ja sehr unkompliziert hat bestens geklappt und die Quallität ist auch noch gut.
Vielen Dank dafür.
Text excerpt from page 186 (click to view)
3.3.2
TQSB-2 PCB (1) (2) (3) Remove the pulse motor (see 3.3.1). Remove the connector O from the TQSB-2 PCB P. Remove the screw Q and remove the TQSB-2 PCB P.
Note : Refer to Detall A in the previous page.
3.3.3 Hopping Roller Shaft Assy and One-way Clutch Gear (1) (2) Follow up to step (3) of 3.3.1 and remove the hopping frame assy. Remove the screw 1 and remove the earth plate 2. Remove the sensor lever 7 and remove the ground plate 6. Remove the gear 3 and remove the metal bush 5 and hopping roller shaft assy 4. Remove the E-ring A and remove the one-way clutch gear B on the right side of the feed roller 0.
(3)
Note : The metal bush C also comes off. Be careful not to lose it.
