This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
It was easy done, and I got exactly what I was looking for.
Text excerpt from page 43 (click to view)
Installing Units into Bays
When shipped, your notebook is equipped with the CD-ROM drive in the right-side bay and with the floppy disk drive in the left-side bay. You can uninstall these drives and install other units such as the battery pack and the AC adapter. � After installing or uninstalling the floppy disk drive, change the settings. See the end of this section. � You can install the AC adapter only in the left-side bay. � You can install the CD-ROM drive only in the right-side bay.
2
Right-side Bay
The right-side bay is installed with the CD-ROM drive when the notebook is shipped. You can install the following units into the right-side bay.
� �
1. 2. 3. 4.
Battery pack Floppy disk drive
To uninstall the unit in the right-side bay: Turn off the notebook. Disconnect the AC adapter and all the peripheral devices. Turn the notebook upside down on a flat place. Slide the bay lock latch to the releasing position, and gently draw the unit out.
The bay lock latch 1 2
Figure 2-2. Uninstalling the unit in the right-side bay To install the unit in the right-side bay: 1. Make sure the notebook is turned off and upside down.
