|
|
|
Who's Online
There currently are 5879 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect copy, im very satisfied, i was need the diagram over the powersupply and
the copy was very sharp
;
This is exactly the service manual I needed.
Complete with all schematics, partslists, PCB layouts and alignment instructions.
This manual covers both the T-4970 en T-488F Onkyo tuner.
 ;
IF PRINTED CIRQUIT BOARD WIRING VIEW WAS ONE TONE LIGHTER, THEN 5 STAR RANK HAS TO BE MY CHOISE.
;
Very usefull, good quality drawings !
Muito útil encontrei todas as informações necessárias.
;
Wanting to repair a neighbours tape recorder I needed the necessary information, it makes it easier. Although the service manual is described as "Language : English" To my dismay I found that it is entirely written in German, a language I do not understand. At least I now have the schematics which will help of sorts. I may not use this service again due to the laguage difficulty after all when it states English you do not expect it to be entirely in another language.
Disconnecting drive from computer Storing the peripheral cable
or if you are using drive connected with the i.LINK cable.
Follow procedure below to disconnect this from your computer. Store peripheral cable inside when you are not using the drive
Notes
� Before disconnecting the drive, close any open programs. Open door on rear of the drive.
1
� When using the drive an R505 series computer with a docking station, disconnect
drive from computer as described below before removing the docking station from the computer. Securely connect to the peripheral cable
2
� If message below appears when you attempt to disconnect the drive, close any connector.
running software, wait for a while and then repeat the procedure.
�Problem Ejecting Sony i.LINk Hard Disk Drive IEEE 1394 SBP2 Device. The device �Generic volume� cannot be stopped right now. Try stopping the device again later�.
z Hint
To use drive again after disconnecting the peripheral cable or i.LINK cable, perform steps described in section �Connecting the Drive� on page 9. The drive will be detected automatically by your Windows operating system.
1 Double-click icon on the taskbar. 3 Close the door.
Note When using connected with i.LINK cable, the drive will not function Select �Sony i.LINK Hard Disk Drive IEEE 1394 SBP2 properly if peripheral cable is not correctly stored in the drive. Device�, and then click �Stop�.
The �Safely Remove Hardware� screen appears.
1�7
2
The �Stop a Hardware Device� screen appears.
3 Select the device you selected in step 2, and then click �OK�.
The message �The Sony i.LINK Hard Disk Drive IEEE 1394 SBP2 Device� can now be safely removed from the system appears.
4 Click �OK�, then click �Close� to close the screen.
You can now disconnect the drive from your computer.
5 Disconnect peripheral cable or the i.LINK cable.
Note
Confidential
If you are using drive with i.LINK cable connected, disconnect the AC adapter after disconnecting the i.LINK cable.
PCGA-HDM06 (J/AM)
20 21
|
|
|
> |
|
