I used your service and I found myself well I need service manual teac v plate 770 and I was able to access and remove the belt that erno routes. thanks I recommend it to all
At first I thought there had been a mix up as I required the service manual for the cassette unit and the one supplied was for the CD unit. However when I scrolled further down I realised that both had been scanned together! This enabled me to dismantle and repair the cassette unit as intended and I also have a copy of the manual for both the CD and graphic equaliser units should I ever need them. Thanks very much for a great service.
Excelent service, the manual is complete, very cheap and fast
Alberto
Text excerpt from page 40 (click to view)
1
2
3
4
8.5 MECHANISM ADJUSTMENT
A
1 Tangential and Radial Height Coarse Adjustment START
� Remove the 05SD Pickup Assy from the Traverse Mechanism Assy-S. � Remove the joint and the joint spring of the 05SD Pickup Assy.
05SD Pickup Assy
B
Note: Before removing the flexible cable for the pickup, soldering of the pickup circuit is necessary. For details, see "7. DISASSEMBLY".
Joint Joint Spring
� Pass through the guide shaft to a new 05SD Pickup Assy. � Attach it to the Traverse Mechanism Assy-S.
C
05SD Pickup Assy
Guide Shaft
D
� Put the joint between the Tangential (or Radial) adjustment screw and the mechanism base and turn each screw to adjust the height. (Refer to "8.1 ADJUSTMENT ITEMS AND LOCATION".)
Joint
7.5mm Mechanism base
E
� Attach the Traverse Mechanism Assy-S to the 05 LOADER Assy. � Turn it over and attach the joint and the joint spring. � Arrange the flexible cables. (Refer to "7. DISASSEMBLY".)
