|
|
|
Who's Online
There currently are 5209 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Awesome manual. Complete diagrams of all board assemblies as well as how to get to each part of the t.v. down to the individual screws and their locations. Get it.
;
perfect copy, im very satisfied, i was need the diagram over the powersupply and
the copy was very sharp
;
This is exactly the service manual I needed.
Complete with all schematics, partslists, PCB layouts and alignment instructions.
This manual covers both the T-4970 en T-488F Onkyo tuner.
 ;
IF PRINTED CIRQUIT BOARD WIRING VIEW WAS ONE TONE LIGHTER, THEN 5 STAR RANK HAS TO BE MY CHOISE.
;
Very usefull, good quality drawings !
Muito útil encontrei todas as informações necessárias.
1
2
3
4
How to replace the fan in the ATX Power Supply unit
A
Removing the fan
1 Remove the switch-barrier fixing screw on the ATX Power Supply unit (DXF1001) then slide the switch barrier, as indicated in the figure. Note: Be sure to set the POWER switch to OFF and disconnect the AC power cord from the AC outlet before starting this step.
Switch-barrier fixing screw Switch barrier ATX Power Supply Unit (DXF1001)
B
2 Remove the fan guard, then remove the fan and disconnect the harness from the fan connector.
C
Fan Cleaning
Fan connector Remove the fan.
Cleaning paper : GED-008
Attaching the fan
1 Connect the harness to the fan connector and install the fan into the panel. Push the harness inside.
Notes: � Place the fan so that the name plate of the fan can be seen from the front. � Use the Fan Unit (DZM1001) dedicated to the ATX Power Supply unit (DXF1001).
Fan Cleaning Cleaning paper : GED-008
D
Push the harness inside so that it will not come out. Name plate can be seen.
Hook the slots.
2 Attach the fan guard.
Close.
E
3 Slide the switch barrier and tighten the screw.
1. Slide
F
2. Tighten the screw.
160
1 2
PRV-LX1
3 4
|
|
|
> |
|
