|
There are currently no product reviews.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
 ;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
1
2
3
4
- Bonding Position
A
Make come near C888 and C887 and them apply bond from the top. 35 pts : GEM1017 3 pts : GYL1006
Hold here.
B
Hold here.
C
D
2 : Apply bond : the bond must not flow into screw hole.(C8,C9)
3 pts BOND LOCK 35 pts Capacitor
Press the thermistor against the transformer and apply an adhesive as the end of the thermistor touches the transformer.
Adhesive
E
Press
*Bond should be applied both of parts and PCB. *Be aware not to apply bond on contact point of connector, seat area of screw.
* TACK-FREE TIME 10 minutes
* TACK-FREE TIME 5 minutes
Note) When applying bond to two Film Capacitors (C887 and C888) , attach them and apply bond.
F
16
PRS-D1200SPL/XU/UC
1 2 3 4
|
