I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
e. Set the mean value (omission below decimal point) of "A" and "B" to the CW INDEX setting value.
4. POWER ON SHUTTER · OPEN: Opens the shutter when power ON. · CLOSE: Closes the shutter when power ON. 5. POWER OFF SHUTTER · IGNORE: Does not control the shutter when power OFF. · OPEN: Opens the shutter when power OFF. · CLOSE: Closes the shutter when power OFF. 6. ERROR OSD Displays the lamp status with OSD when you do not see the status LED lights because the rear projection, etc.
7. SIGNAL DATA ALL ERASE Resets the setting value of each signal to the initial value of the factory shipment. 8. MODEL Sets the model name. · Set it when you install a new A-P.C.Board without maintenance (data transfer or IC replacement) of adjustment data etc. according to the paragraph 7.2.1. * Never set it to a model name different from the model that installs the new A-P.C.Board. If a different model name is set, it becomes impossible to output normal pictures after the next startup. * When a new A-P.C.Board is installed without maintenance of adjustment data, it is required to adjust the color wheel.
4.3.2.
SUB KEYSTONE
"SUB KEYSTONE" is added to KEYSTONE in the "POSITION" menu. If KEYSTONE and "Lens shift" are used at the same time, the right and left is corrected in the unbalance. At this time, only the right side can be corrected by SUB KEYSTONE.
