Even if the PDF is a scan, I can read the information I need.
The price is affordable and the service (mail sending) is very fast.
Thanks ! Regards. William (Fan of Kenwood)
1. Turn the projector upside down. 2. Unscrew the 6 screws.
7.4.
Removal of G-P.C.Board
1. Remove the connector metal fittings with the G-P.C.Board according to the section 7.3. "Removal of A-P.C.Board". 2. Unscrew the 1 screw and remove the G-P.C.Board .
3. Return the projector to the normal position. 4. Remove the upper case.
7.3.
Removal of A-P.C.Board
1. Remove the upper case according to the section 7.2. "Removal of Upper Case". 2. Unscrew the 2 screws and remove the lamp house. 3. Unscrew the 1 screw and remove the connector cover 4. Unscrew the 3 screws fixing the S-P.C.Board. 5. Unscrew the 3 screws fixing the A-P.C.Board.
7.5.
Removal of S-P.C.Board
1. Remove the upper case according to the section 7.2. "Removal of Upper Case". 2. Unscrew the 3 screws. 3. Disconnect the flexible cable and remove the S-P.C.Board.
6. Disconnect the connectors from/to the A-P.C.Board, then remove the A-P.C.Board block with the G-P.C.Board and SP.C.Board. 7. Unscrew the 8 screws and remove the connector metal fittings. Note: · The G-P.C.Board is attached on the connector metal fittings, and it is connected with the A-P.C.Board. Work carefully when removing the connector metal fittings.
7.6.
Removal of WL-P.C.Board (PTLB50NTU/E/EA only)
1. Remove the upper case according to the section 7.2. "Removal of Upper Case". 2. Unscrew the 3 screws and remove the WL-P.C.Board with wireless LAN module.
