Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
Text excerpt from page 39 (click to view)
Editing Features
6, 7PAUSE
6
Press (PAUSE) to start Audio Dubbing. �A.DUB � indication appears. � Connect the Palmcorder to the TV in order to monitor the sound. (p. 33)
To listen to the desired audio sound, set the AUDIO setting of the VCR mode MENU (Menu OSD: p. 61) as follows: AUDIO:The following selections are available for 12 bit AUDIO dubbed recordings only (sound recorded in SP mode only). ST 1 ST 2 MIX Set this position to listen to the original sound. Set this position to listen to the audio dubbed sound. Set this position to listen to both the original sound and the audio dubbed sound. Only NTSC (National Television Standards Committee) recorded tapes can be audio dubbed. The following screen appears if the tape was not recorded in NTSC format.
7
Press (PAUSE) to stop Audio Dubbing.
Note
� 16 bit dubbed sound completely erases the original 16 bit recorded sound. � If you dubbed using 12 bit AUDIO recording and then selected AUDIO-MIX in the menu for playback, the sound will be stereo regardless of the AUDIO-OUT setting. � If you recorded in LP mode, you cannot use the A.DUB feature.
� If the microphone used for dubbing gets too near the speaker of your TV, a howling noise (feedback) may occur. � If the tape position is in or was started in a blank section, you cannot use the A.DUB feature.
