|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
 ;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
;
Complete manual including mechanical part in good pdf quality. Shaded greys of the pcb due to pdf not perfect but usable.
;
Nice pdf file of the manual sent promptly. Thanks.
slightly and equally adjust Screw A, Screw B, and Screw C on the A /C Head Unit to achieve the sub control signal level of 500 mV200 mV. (Sub Control Signal level will decrease when rotating screws clockwise, and increase when rotating screws counterclockwise.)
Fig. M4-1
Fig. M4-2
8.2.2.1.3. A/C HEAD AZIMUTH ADJUSTMENT
Purpose: To adjust the position and height of the A/C Head so that it meets the tape tracks properly. Symptom of Misadjustment: If the position of the A/C Head is not properly adjusted, the Audio S /N Ratio will be poor. 1. Connect the Audio/Video Cable on the camcorder. 2. Connect the oscilloscope to audio output jack. 3. Playback the Alignment Tape (VFMS0004H6C). 4. Adjust Screw C (Azimuth) on the A/C Head Unit so that the output level is at maximum.
Fig. M5
86
|
|
|
> |
|
