I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
I was so pleased to get the owner`s manuel within one hour! Thanks again.
Regards
Werner
Text excerpt from page 9 (click to view)
R-754M/R-765M O/M & C/B
02/01/2002
13:06
Page 7
Website: http://www.sharp.co.uk/support
Help Line: 08705 274277 (office hours)
BEFORE OPERATION
Plug in the oven. 1. The oven display will flash: 2. Press the STOP/CLEAR key. 3. The display will show: To set the clock, see below. When using the oven for the first time: Heat the oven using GRILL mode without food for 20 minutes. See note on page 9. 1. 2. x1 3.
SETTING THE CLOCK
There are two setting modes: 12 hour clock and 24 hour clock: 1. To set the 12 hour clock, press the DELAY START/CLOCK SET key once, will appear in the display. 2. To set the 24 hour clock, press the DELAY START/CLOCK SET key twice, will appear in the display. Example: To set the 24 hour clock to 23:35: 1. Select the 24 hour clock. 2. To enter the hours press the 10 MIN key twice then the 1 MIN key three times. 3. To change from hours to minutes press the DELAY START/ CLOCK SET key once. x1
x2
x2 4. To enter the minutes press the 10 MIN key 3 times then the 1 MIN key 5 times.
x2
x3
x1
5. To start the clock press the DELAY START/ CLOCK SET key once.
Check the display:
x3
x5
x1
STIR TURN KG�LB GRILL MICRO COOK
NOTES: � To check the time of day during a cooking process, press DELAY START/CLOCK SET key and the time of day will remain on the display as long as you keep your finger on the key. This does not affect the cooking process. � If the clock is set, when cooking is complete, the display will show the correct time of day. If the clock has not been set, the display will only show when cooking is complete. � If the electrical power supply to your microwave oven is interrupted, the display will intermittently show: after the power is reinstated. If this occurs during cooking, the programme will be erased. The time of day will also be erased. � When you want to reset the time of day, follow the above example again.
