ZOOM RFX-2200
Owner's Manual

Changing the Value of an Effect Parameter
Each effect of the RFX-2200 consists of certain effect parameters which determine the intensity and tone character of the effect. Effect parameters can be adjusted with the following edit controls.

MIX control
The MIX control serves to adjust the balance between original sound (DRY) and effect sound (WET). When the control is turned fully counterclockwise, only the original sound is output. When the control is turned fully clockwise, only the effect sound is output.
Lights up when mixing balance was changed

REV CHARACTER (EDIT 1) control REV TIME (EDIT 2) control REV EQ LOW (EDIT 3) control REV EQ HIGH (EDIT 4) control
These controls serve to edit parameters of the currently selected effect. (For information on which parameters can be edited for which effect, please refer to pages 14 - 22.)
Lights up when parameter was edited

Original sound only

Effect sound only

Editing a Patch /Useful Functions

� When the MIX control is moved, the mixing balance setting (0 - 99) is shown on the display for about 2 seconds. � When the mixing balance setting is changed from the last stored condition, the LED of the MIX control lights up. When the setting is returned to the original value, the LED goes out.

� When any of the above controls is moved, the corresponding parameter value is shown for 2 seconds on the display. � When a parameter setting is changed from the last stored condition, the LED of the respective control lights up. When the setting is returned to the original value, the LED goes out. When the effect is switched, the LEDs of all controls except the MIX control light up.

Storing an Edited Patch
If an edited patch is not stored in memory, the edited contents will be lost when another patch is selected. To keep the edited patch, store it in memory as follows.

1. 2.

Select the patch and edit it. Press the STORE key.
The patch number on the display flashes.
STORE key

the patch.
To use the same patch number, this step is not necessary.

4.

Press the STORE key once more to execute the store operation.
The patch is stored in memory and the flashing of the display stops. If you press the CANCEL key instead of the STORE key, the operation is aborted and the unit reverts to the condition of step 1.

3.

Use the VALUE UP/DOWN keys to select the patch number in which you want to store

Useful Functions
The RFX-2200 offers various handy functions for editing patches.

Checking the parameter value (parameter check)
You can also check a parameter value without moving its associated front-panel control.

1.

Press the PARM CHECK key.
The PARM CHECK mark (.) in the center of the display appears and the EFFECT TYPE selector LED flashes for about 2 seconds. This indicates that the effect setting is being checked. The number of the currently selected effect (1 - 8) is shown for about 2 seconds on the display. The display then reverts to the original condition.
PARM CHECK key

Effect number

LED flashes

PARM CHECK mark (.)

2.

To check another parameter, press the PARM CHECK key again before the display indication reverts to the previous condition.

8

ZOOM RFX-2200