perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
Text excerpt from page 6 (click to view)
Choosing
the proper
location
Read the following items before choosing the location for the freezer. See �Completing the installation� below before sliding freezer into place. 1. Pick a safe place, indoors, away from flammables such as gasoline. 2. Check the strength of the floor. It should hold the weight of a fully loaded freezer. 3. Allow at least 3 inches (7.5 cm) of air space on both sides of the freezer and 2 inches (5 cm) between the back of the freezer and the wall. Leave room above the freezer to open the lid. 4. It should not be necessary to remove the lid during installation. If, for any reason, the hinges need adjustment, see the label on the back of your freezer and contact an authorized Roper service company. Do not cover the freezer with items such as blankets, sheets, tablecloths, etc. This reduces air circulation.
NOTE:
Room to open Ild
2 inches at back
Completing
the installation
Level the freezer from side to side and front to back so that the lid will seal properly. Use shim(s) to level the freezer if necessary.
Installing
(on some
the defrost
drain cover
models)
1. Remove defrost drain cover from the
literature package. 2. Push drain cover into drain hole as illustrated.
