This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Text excerpt from page 28 (click to view)
MAINTENANCE
8. Place one foot on the front edge of the cutting unit. Raise the front edge of the unit slightly and unhook the height adjustment strut.
9. Remove the bolt and pull out the cutting unit.
Removing the belt
Starting point when Removing the belt: � � No unit attached to the Rider. The front part of the belt hangs loose.
The entire belt is only dismantled as set out below, when the snow plough is fitted on the Rider. � � Remove the guide plate from underneath the drive wheel. Use a 13 mm spanner. Prise the belt off the middle pulley and remove the belt.
8 9
