5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
very helpful, the information in these manuels are very detailed
Text excerpt from page 15 (click to view)
ice maker mold and lead to poor ice quality. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained.
Removing
(on some models)
the ice maker
storage
bin
Remove, empty, and clean the storage bin if: l the ice dispenser has not, or will not, be used for a week or more. l a power failure causes ice in the bin to melt and freeze together. l the ice dispenser is not used regularly. To remove Ice bin: 1. Pull the covering panel out from the bottom and slide it to the rear.
2. Lift the signal arm so it clicks into the OFF (up) position. Ice can still be dispensed, but no more can be made.
3. Lii the front of the storage bin and pull it out. 4. Empty the ice bin. Use hot or warm water to melt the ice if necessary. Never use anythlng sharp to break up ice in the bin. This can damage the bin and dispenser mechanism. 5. Wash with mild detergent. Rinse well. Do not use harsh or abrasive cleaners or solvents. 6. When replacing the bin, make sure it is pushed in all the way. Then push the signal arm down to the ON position to restart ice production. 15
