perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
Text excerpt from page 9 (click to view)
Removing
the crisper
and cover
To remove the crisper: 1. Slide crisper straight out. 2. Replace crisper by sliding it straight in. To retnove the cover: 1. Lift the back and slide it to the rear until the front can be lifted. 2. Lii cover up and out. To replace the cover: 1. Slide the front cover tabs into the rear of the front supports on the refrigerator walls. 2. Lower back of cover into place.
Using
the ice cube trays
If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get. To remove ice: 1. Hold tray at both ends. 2. Twist slightly.
Using
the optional
automatic
ice maker
If you plan to add an automatic ice maker later (Part No. IMKIT), there are a few things you will want to know: l The ON/OFF lever is a wire signal arm. Down . . . to make ice automatically. up . . . to shut off the ice maker. .. NOTE: Do not Ucn ice Won until It IS Gonnected to the water wwl~. lnstructlons hook up WC mached to the back of the refrigerator cabinet. The dial or lever on the side of the ice maker l changes the size of the cubes.
l
Raise signal arm to stop ice.
Lower signal arm to start it
l
l
Shake the bin occasionally to keep cubes separated and to obtain increased storage capacity. It is normal for ice crescents to be attached by a corner. They will break apart easily. You will hear water running when ice maker is working. You�ll hear ice fall into the bin. Don�t let these sounds bother you.
