I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
I was so pleased to get the owner`s manuel within one hour! Thanks again.
Regards
Werner
Text excerpt from page 27 (click to view)
English
4. Adjust the speaker output levels.
� To adjust the center speaker level, press CENTER �/+ (from �10 dB to +10 dB). � To adjust the left rear speaker level, press REAR�L �/+ (from �10 dB to +10 dB). � To adjust the right rear speaker level, press REAR�R �/+ (from �10 dB to +10 dB).
� CENTER +
5
6
� REAR�L +
On the front panel: You can also use the buttons on the front panel to adjust the Surround modes. However, no test tone is available when using the buttons on the front panel. So, make adjustments while listening to the sound of the source played back.
8
9
MENU
1. Press DSP MODE repeatedly until �THEATER� appears on the display.
� The Ÿ PRO LOGIC and DSP indicators also light up on the display.
DSP MODE
� REAR�R +
10
+10
ENTER
2. Adjust the speaker output levels.
1) Press ADJUST repeatedly until one of the following indications appears on the display. �CENTER LEVEL�: To adjust the center speaker level. �REAR L LEVEL�: To adjust the left rear speaker level. �REAR R LEVEL�: To adjust the right rear speaker level. � Once you have pressed ADJUST, MULTI CURSOR % / � can be also used for selecting the speaker.
ADJUST
5. Press TEST again to stop the test tone.
TEST
1
6. Press EFFECT to select an effect level you want.
� Each time you press the button, the effect level changes as follows:
EFFECT
4
MULTI CURSOR
DSP EFFECT 1
DSP EFFECT 2
DSP EFFECT 3
DSP EFFECT 5
DSP EFFECT 4
As the number increases, JVC Theater Surround becomes stronger.
2) Press MULTI CURSOR @ / # to adjust the selected speaker output level (from �10 dB to +10 dB). 3) Repeat 1) and 2) to adjust the other speaker output levels.
4. Adjust the effect level.
1) Press ADJUST repeatedly until �DSP EFFECT� appears on the display. � Once you have pressed ADJUST, MULTI CURSOR % / � also can be used for selecting �DSP EFFECT.� � The display changes to show the current setting. 2) Press MULTI CURSOR @ / # to select the effect level. � As you press it, the effect level changes as follows:
ADJUST
MULTI CURSOR
DSP EFFECT 1
DSP EFFECT 2
DSP EFFECT 3
DSP EFFECT 5
DSP EFFECT 4
As the number increases, JVC Theater Surround becomes stronger.