JVC RX-80PGD
Owner's Manual

Once you have set the surround modes, you can use the same adjustment every time you want to activate the surround you want. The receiver memorizes surround adjustments for each mode. Note: When you select �DVDMULTI� as the source to play, you cannot select or adjust the surround mode. On the front panel:
DAP/SURROUND MODE

1. Press DAP/SURROUND MODE so that the Control % / � / @ / # buttons work for selecting the DAP/surround modes. The lamp next to the button lights up. 2. Press Control @ / # to select the surround mode. The SURROUND indicator lights up on the display. Each time you press the button, the DAP and surround modes alternately come into effect. 3. Press Control % / � until the surround mode you want appears on the display. Each time you press the button, the surround modes change as follows (the indicator of the selected surround mode also lights up on the display):

PROLOGIC SURR OFF
(Surround Off)

3CHLOGIC THEATER2 THEATER1

PROLOGIC: 3CHLOGIC: THEATER1:

Select this mode to watch a video source with Dolby Surround when you have connected the rear speakers (and a center speaker). Select this mode to watch a video source with Dolby Surround when you have connected a center speaker and no rear speakers. Select this mode to watch a video source with Dolby Surround when you have connected the rear speakers (and a center speaker). This mode gives you the feeling of a small movie theater with a seating capacity of 100. Select this mode to watch a video source with Dolby Surround when you have connected the rear speakers (and a center speaker). This mode gives you the feeling of a large movie theater with a seating capacity of 1000. No surround mode is applied.

Front panel

THEATER2:

SURR OFF:

DAP/SURROUND/DVD MULTI ADJUST

4. Press DAP/SURROUND/DVD MULTI ADJUST so that the Control % / � / @ / # buttons work for adjusting the surround mode. The lamp next to the button lights up.

To be continued to the next page

Page 32

English

Preparing for the surround mode