Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Text excerpt from page 7 (click to view)
4
Connect the speaker cables.
Rear of the speaker
� Preventing the speakers from falling over
Preparation Attach screw eyes (not included) to secure the speakers to the wall (� diagram below). �You will need to obtain the appropriate screw eyes to match the walls or pillars to which they are going to be fastened. �Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that may not have strong enough support. Improper attachment may result in damage to the wall or speakers. To prevent the speaker from falling over, thread the string (not
Twist off the vinyl tips of the speaker cables. �If the speaker cables do not have vinyl tips, directly connect them to the terminals.
_: Copper `: Silver
Push ! Press the speaker cable into the groove.
included) from the wall to the speaker as shown and tie tightly.
[HT730] [HT733]
Screw eye (not included) String (not included)
If there is any excess speaker cable, thread the speaker cable into the opening near the top of the pipe while pulling the speaker cable from the bottom of the base.
Rear of the speaker Wall
Approx. 150 mm (5 29/32z)
5
Fasten the speaker cable to the base.
[HT930]
Screw eye (not included) String (not included)
�Using the same polyfoam as in procedure 2 will assist you in safely and securely fastening the speaker cables.
2 Fit the speaker 1 Press the speaker
cable and thread between the hooks. cable into the base cover groove as far as possible. Rear of the speaker Wall Approx. 150 mm (5 29/32z)
