I'm quite impressed. I had to wait 24 hours for my manual (quite a rare one) but I got it and the quality was good. Also, from trawling the web, these prices are by far the best.
Was very fast and accurate service. Just what I needed. I recommend to everyone.
Text excerpt from page 24 (click to view)
DISASSEMBLY INSTRUCTIONS
1. REMOVAL OF MECHANICAL PARTS AND P.C. BOARDS
1-1: TOP CABINET/FRONT CABINET (Refer to Fig. 1-1) 1. 2. 3. 4. Remove the 5 screws 1. Remove the Top Cabinet in the direction of arrow (A). Unlock the 4 supports 2. Remove the Front Cabinet in the direction of arrow (B).
Top Cabinet
1-3: DECK CD (Refer to Fig. 1-3) 1. Make the short circuit on the position as shown Fig. 1-3 using a soldering. If you remove the Deck CD with no soldering, the Laser may be damaged. 2. Disconnect the following connectors: (CP2301, CP2302, CP2603). 3. Remove the 4 screws 1. 4. Remove the Deck CD in the direction of arrow.
1
Pick Up PCB
1 1
Deck CD
1
1
1
1
Front Cabinet (A)
1
Make the short circuit using a soldering.
1 2
(B)
2 2 2
Fig. 1-1 Fig. 1-3 1-2: POWER PCB (Refer to Fig. 1-2) 1. Disconnect the following connectors: (CP4005, CP4006). 2. Remove the 3 screws 1. 3. Remove the Power PCB in the direction of arrow.
1 1 1
Power PCB
NOTE When the installation of the Deck CD, remove all the soldering on the short circuit position after the connection of Pick Up PCB and DVD PCB connector. 1-4: DVD PCB (Refer to Fig. 1-4) 1. Remove the 4 screws 1. 2. Remove the 3 screws 2. 3. Remove the DVD PCB in the direction of arrow.
2
DVD PCB
