|
|
|
Who's Online
There currently are 5677 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
1.2 The initial screen is not displayed on the LCD. If the initial screen is not displayed on the LCD, check the following items. (1) Check the LED on the front If the LED does not light, proceed to 1.1. (2) Check the backlight If the backlight does not light up, separate the DVD player into top assembly and bottom assembly, and check the connector harness, and check the connectors for defects. If the connector harness is broken: Replace the broken harness. If the connector harness is not broken: Remove the LCD cover and plate of the LCD unit and check the following: Check the connector of the FL inverter harness, replace the FL inverter or the LCD. If the connectors are good, replace the FL inverter or the LCD. (3) Check the lighting of LCD If the LCD does not light, separate the DVD player into the top assembly and bottom assembly, and check the inverter harness, and check the connectors on the main board. If the connector is broken: Replace the inverter harness or the main board. If the connector is not broken: Remove the LCD cover and plate of the LCD unit, and check the connection to the harness of the LCD unit. If a bad connection is found. Connect the LCD harness to the LCD unit. Other than the above Replace the LCD unit or the main board.
|
|
|
> |
|
