|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
 ;
I liked the product. I would use their sevices again.
;
I Recently purchased yet another Service Manual from Owner-Manuals.com, this time for a Sony EVS700ES/UB Videocassette Recorder. The Manual was available for upload within two hours and is an Extremely Good copy, as some of this I was able to enlarge to get even better detail.
Once Again, Very happy with the result!
;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
FOR PRECAUTION OF REASSEMBLY AND DISASSEMBLY
(Front SP)
The grille is attached to the cabinet by catches. Detach by pulling it toward you. The woofer is attached to the cosmetic baffle by 4 internal screws. The cosmetic baffle is atached to the cabinet by 4 external screws and. To detach it, first insert a sharp-pointed tool like an eyeleteer into the catch and push up. Next unfasten screws for the cosmetic baffle. Then unfasten those screws. When attaching the woofer, face its terminal downward. When attaching the cosmetic baffle on the cabinet by screws. The tweeter is attached to the cosmetic baffle by 2 internal screws. The cosmetic baffle is atached to the cabinet by 4 external screws. To detach it, perform same as the woofer.
4. Reassemble the subwoofer, as shown below: 4-1 Apply adhesive to the cosmetic baffle and press it into the cabinet. 4-2 Apply adhesive to the interior surface of the circumference of the damper previously removed. 4-3 Insert the damper into the cabinet through the hole where the speaker was, and adhere it so that the end of the cosmetic duct is on the same plane as the surface of the damper. 4-4 Secure the speaker to the cabinet with the four screws previously removed.
(Center SP and Surround SP)
The grille assy is attached to the cabinet by external screws (8 screws for center SP, 4 screws for surround SP) from backside. The Speaker is attached to the grille by 4 internal screws. To detach it, first unfasten screws for the grille and the cabinet. Then unfasten those screws.When attaching it, face its terminal horizontal. When attaching the grille after connecting the cord, face its terminal toward the cord of the cabinet.
(Sub Woofer)
The woofer is attached to the back board by 4 external screws. To detach it, unfasten those screws. The input terminal is attached to the back board of the cabinet together with the adhesive by press-fitting. To detach the input terminal, pry it open by inserting a flat blade screwdriver into the upper and lower slot of the input terminal. To attach the input terminal, replace it on the back board of the cabinet correctly together with the adhesive by press-fitting. (The red terminal is right-side.) The cosmetic baffle is attached to the baffle of the cabinet together with the adhesive by press-fitting. To detach the cosmetic baffle, pry it open by inserting a flat blade screwdriver into the lower slot of it. To attach the cosmetic baffle, replace it on the baffle of the cabinet together with the adhesive by pressfitting. How to replace the cosmetic baffle and cosmetic duct 1. Remove the speaker from the cabinet, first removing the four screws. 2. Reach through the hole where the speaker was originally located and pull out the damper attached at the end of the cosmetic duct by hand. (Damper: See Product Appearance 11.) Note: Detach the damper with great care so as not to damage the interior surface of its circumference. 3. With the aid of a flathead screwdriver inserted through the slit at the lower part of the cosmetic baffle, remove the cosmetic baffle from the cabinet.
|
|
|
> |
|
