|
|
|
Who's Online
There currently are 5450 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Bon produit. Permet de corriger les couleurs et de redonnez un petit coup de jeune à vos vieilles vidéos. On regrettera juste le manque d'une prise s-vidéo.
 ;
Quality scan of the actual service manual, just what I was looking for.
;
Straightforward ordering process. Service manual scan was clear & easy to read. Very comprehensive instructions for alignment. Excellent, thank you.
;
Fast, clear and useful. Important for me: the manual is in German.
;
Very good quality. Some parts are not fully readable, but the fundamental ones are fine.
S-FCRW230
7. ADJUSTMENT
ATTENTION
¶ Don� t make speaker terminal short circuit during the power supply injection. ¶ Since the PRIMARY part of the AMP ASSY is not insulated, be careful of electric shock. ¶ Be sure to disconnect the power supply cord before touching the AMP ASSY board. ¶ Discharge the C13, C14 capacitors!
7.1 MEASURING INSTRUMENTS
¶ Provide yourself with the following measuring devices: (1) Digital voltmeter (2) Oscilloscope (3) Attenuator (4) Low-frequency oscillator
7 GAIN Adjustment
(1) Decrease the level of the Adjustment Variable resistors (VR) for the channel to adjusted. (2) Increase LEVEL VOLUME maximum. (3) Adjust GAIN (VR41) volume. ¶ Apply the signal to the Line IN of JA201. ¶ As the gain from IN to SPEAKER OUT 53dB(freq. = 50 Hz), input of 10mVrms to Input results in output of 0.72 W (4.5 Vrms/28 W) at SPEAKER OUT. ¶ After power-supply ON, after waiting abut 10 seconds, it adjustment because, wave form rises behind time for slow start operation.
Test Point
A
Digital Voltmeter +
28� 3W
AMP ASSY
SIDE A
Adjustment VR VR41 Gain Adj
15
|
|
|
> |
|
