|
|
|
Who's Online
There currently are 5710 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I was having a hard time finding the problem with this Mackie 1604 unit. I didn't have a schematic. Went looking on the web and found your site and the price was more then reasonable. Ordered it and within the hour had the manual and within 15 minutes had the unit fixed. Best $4.99 I ever spent. Thank you.
Doug
;
This is a service manual in every sense of the word ( French and German versions of the text are included, as well as English..)
There are explanations of the mechanical and electrical functions, plenty of mechanical drawings, and the needed schematics. The quality of the scanning is excellent - all the component values are clearly legible - and very usefully there are pcb component layouts, so you can find a component on the schematic, and then very quicky pinpoint its physical location on the relevant pcb.
I cannot see how I can give this manual any less than the maximum 5 stars! Great value for money, which will pay for itself immediately. Excellent all round!
;
the manual is great and especially hard to find... thanks for the great service and having a hard to find manuel_
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.50 of store credit for Your review.
;
hat alles sehr gut geklappt. Das Servicemaual ist gut zu verwenden. Die Pläne und Schrift
ist klar und leserlich. Außerdem preiswert. Grüße an alle Hifi-Bastler
SH-HT441WP
Step 6 : Ensure that the Green LED (Digital Transmitter) is light-up. If it does not light up, there is no established link between them. (No communication is established between the digital transmitter & receiver unit). It could be due the below possible causes: 1. The digital transmitter unit is not fully inserted into the slot of the service jig. (Note: The wireless link indicator light will be flashing if the digital transmitter unit is not fully inserted into the slot. 2. The 5V DC power supply to the service jig is not connected properly or it is connected loosely. 3. The digital transmitter or the receiver unit is not operating properly due to power supply not connected properly. (Refer to section 9.3.1 for troubleshooting procedures for the receiver module P.C.B.) Step 7 : Ensure that the audio input into the digital transmitter can be heard from the speaker at the digital receiver unit. If there is no audio output at the speaker, check and confirm the connection of speakers at the rear of the receiver unit. (Refer to section 9.3.3 for the troubleshooting procedures for checking of power Amp IC).
32
|
|
|
> |
|
