PANASONIC SLSX285
Owner's Manual

Sequential Play

Basic Play

4

Track number in play
VOL

5
VOL

VOL

VOL

C S-XBS TRAIN

Increase

ALL1 M RANDOM SORRY

C S-XBS TRAIN

ALL1 M RANDOM SORRY

Decrease

1
Plug type: 3.5 mm (1/8 in.) stereo

Elapsed playing time of each track

P R O O P

OPEN

Label must face upward.

2
Close the lid

Follow steps 1�5.
In step 2: Connect the stereo headphones and wired remote control to the headphone jack [�]. (Plug in �rmly.) In step 5: The volume range is 0-25. Press and hold to change the volume successively. The volume changes when pressed while the level is displayed. If any other display is shown, it changes to show the current level. (The volume returns to 10 when you disconnect the power source.) �Play stops automatically when all the tracks have been played. �If the unit has been connected to the car audio system, set this unit�s volume to 10, then adjust the volume level on the system.

Operation

To pause play

To stop play

Stop mode

To turn off the unit Off mode
O
FF

Skip forward/ backward (skip function) Rapid forward/ backward (search function)

Press during play. (Press [:] twice to skip to the beginning of the previous tracks.) Backward

�During program play (page 4), these buttons are used to skip forward or backward through the programmed sequence of tracks. �You cannot skip to tracks that have been played in random or random repeat play (page 4). �During program play, 1-track repeat play, random play and random repeat play (page 4), search operation is limited to the current track only.

Note!
Never insert foreign objects into the unit.

Forward Press and hold during play.

Auto power off function
If the unit is left in stop mode for approximately 10 minutes, the unit powers itself off automatically in order to prevent the battery from running down. (If no disc is loaded in the unit, it powers itself off in about 30 seconds.)

For your reference: � � indication
This indication appears for about 30 seconds if [1;] (main unit) or [�/1] (remote control) is pressed when no disc is loaded in the unit or if the disc is not properly secured.

�*� indication
This indication appears for about 10 minutes when the lid is opened. (However, the indication does not appear when the unit is powered off.)

Note on CD-R and CD-RW
This unit can play CD-DA format audio CD-R and CD-RW that have been �nalized§ upon completion of recording. It may not be able to play some CD-R or CD-RW due to the condition of the recording.
§

Finalizing is a process that enables CD-R/CD-RW players to play audio CD-R and CD-RW.

3

H

PUSH

O P

R
OF

F

3

HOLD

R

L

Resume function
The player stores the track where you stopped play and if you press [1 ;] (main unit) or [�/1] (remote control), play resumes from the beginning of the track. The resume function is canceled (play starts from the �rst track) if you open the lid when the unit is in stop mode. It is also usually canceled when you replace the CD while the unit is off. �The resume function may work if you replace the CD while the unit is off. �If you turned the unit off near the end of the track, play may resume from the beginning of the next track. �The resume function works automatically and cannot be turned off.

Button
Press during play.

Display/reference
Press again to restart play.
VOL

Note!

C S-XBS TRAIN

ALL1

M

Press during play.

Total number of tracks
VOL

Removing discs

1 2 3

O

FF

C S-XBS TRAIN

Press [�,OPR OFF] to stop play and disc rotation. Slide [OPEN 1] to open the lid. Press [PUSH] to release the disc.

Total playing time Press during stop mode.
VOL
C

ALL1 M RANDOM

Do not stop the disc by hand or try to remove it before it stops rotating. This can damage CDs.
S-XBS TRAIN ALL1

M

PUS