Good manual. It is complete and of high quality, both text and graphics. The schematics are with the original big size, so it can be viewed or printed without any loss of resulution and sharpness.
All ok. I pay 5 $ and now i have 92 pages of good scaned service manual for my oooooold akai. Now i will try to repair it.
Text excerpt from page 7 (click to view)
SECTION 3 ELECTRICAL ADJUSTMENT
BIAS ADJUSTMENT
Adjustment Procedure: 1. Rotate fully the bias adjusting semi-fixed resistors (RV301 (LCH), RV351 (R-CH)) to the minimum position (counterclockwise). 2. Connect a digital voltmeter to the CN406 (L-CH) and CN407 (R-CH).
pin 1 pin 3 CN406 (L-CH) CN407 (R-CH) � + + �
Connection and Adjustment Location:
[MAIN (A) BOARD] � Component side �
3. Set the slidack to 0 V AC, and press the POWER button (ON) on the set. 4. Raise gradually the slidack voltage up to the rated voltage (230 V AC). 5. At this time, confirm that the speaker relay is turned on (it will click). 6. Adjust the RV301 (L-CH) and RV351 (R-CH) so that a reading of digital voltmeter is from 10 mV to 20 mV. 7. Return the slidack to 0 V AC, and press the POWER button (OFF) on the set.
