The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Text excerpt from page 13 (click to view)
Building-in instructions
Before carrying out any work, remove the plug from the power socket.
Building in the appliance under a worktop
The dimensions of the recessed installation area must correspond with those indicated in the figure.
Grid preparation
Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure).
600
A B
55 min. 0
600
DO013
Installation kit
DO002/2
1xB
2xC
Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure). To position the grid on the appliance proceed as follows: Apply the grid to the base of the appliance by pushing on to the clasps (a) until they click.
1xA 1xK
2xG 2xL 2xF 2xD
18xI
2xE
a
1
a
DO001
1. Two cabinet securing brackets are supplied with the installation pack. They need to be assembled onto the cabinet prior to cabinet being pushed into the Kitchen aperture. - To fit these brackets remove the two screws at the top left and right hand front corners of the cabinet. - Position the two brackets as shown in the figure and replace the two securing screws.
