I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
I was so pleased to get the owner`s manuel within one hour! Thanks again.
Regards
Werner
Text excerpt from page 25 (click to view)
Operating peripheral equipment using the remote control
Programming the remote control code
You can operate other manufacturers� components using this TV�s remote control. Preparations: � Connect the plug of the external component to the wall outlet. � Make sure the component is turned off.
T V
1
POWER
POWER
+
SAP
VOL
CH
OK
VOL
Press and hold POWER and OK together, for at least 5 seconds. � The mode selection buttons flash, then release POWER and OK.
CH
VCR
DBS/CBL
DV D
CH
OK
VOL VOL
2
RETURN EXIT
VCR
T V
DBS
Select the type of the component.
/CBL
D V D
� The selected button lights and all others go out.
CH
MENU
TV/VIDEO
RECALL
MUTE
GUIDE
3
1 4 7
2 5 8 0
3 6 9
1 4
2 5
3 6
Enter the 3-digit infrared code (see pages 26, 27). � Factory default setting: Panasonic � Press POWER to test the operation.
7
R-TUNE
8 0
9
SLEEP PROG
REW
PLAY
FF
Notes: � If the component does not operate with the remote control, repeat the procedure using another code. (Some brands have multiple codes). � If an incorrect code is entered, or if the procedure takes longer than 30 seconds, the programming will fail.
PAUSE
STOP
REC
ASPECT TV/VCR
VCR/DBS CH
To find a code not listed in the index After step 2 above,
TV
Press to select the code. � The potential code is loaded for the device selected in step 2. � Press POWER button to test the operation. � Repeat the steps until the component code is found. It may take many attempts before the correct code is found. Press to store the code.
