Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
We received the manual in a timely manner and it was exactly what we were expecting.
Text excerpt from page 25 (click to view)
3. Remove the three M3x8 Torx screws that fasten the mounting bracket to the bottom case.
4. Lift the bracket at the front and remove it from the bottom case.
Assembly Notes
� � Place the rear of the mounting bracket beneath the lip at the front of the chassis. Make sure the bracket aligns with the holes in the bottom case. Torque the three M3x8 Torx screws to 6 in/lbs (.68 Nm). � Torque the M3x8 Torx screw at the front of the chassis to 6 in/lbs (.68 Nm).
