WHIRLPOOL TGDL400AW0
Owner's Manual

Using

the automatic

cycles

(on some mudds)

Your automatic control senses the dryness of the load and automatically shuts off when the selected dryness is reached. For the first few loads: 1. Set the cycle Control Knob to point to the center dot in your automatic cycle. 2. Select a heat setting to match your load. 3. Feel the dried items when the dryer stops. if the items are d&w than you like, select a setting closer to LESS DRY the next time you dry a similar load. it items are not as dry as you like, select a setting closer to VERY DRY the next time you dry a similar load. The Cycle Control Knob will not move until the load is almost dry or the cool-down portion of the cycle has been reached. After the cool down is complete, the Cycle Control Knob automatically moves to an OFF area and the tumbling stops. NOTE: Your model will not look exactly like the illustration.

Using

the air cycle

(no heat)

Fire Hazard Do not dry plastic or rubber items with heat. Use the air cycle, or line dry. Failure to do so could result in fire or damaged items. The dryer does not heat when the Cycle Control Knob is set in the air cycle. This cycle can be used to fluff or air dry bedding, plastic tablecloths, foam pillows, sneakers, etc. 1. Turn the Cycle Control Knob to the number of minutes you want in the air cycle. Refer to the chart below for suggested times. 2. Push the Start Button. NOTE: Repeat steps above if more time is needed to dry items. TYPE OF LOAD RUBBER, PLASTIC, HEAT-SENSiTiVE FABRICS Foam Rubber-Pillows, bras, stuffed toys PlastioShower curtains, tablecloths Rubber-backed rugs Olefin, Polypropylene, Sheer nylon 8 I CYCLE AND TIME Air 20-30 min 20-30 min 40-50 min 15-20 min