WHIRLPOOL TGS325MQ2
Owner's Manual

To Remove:
1. Open the oven door. Insert door removal pins, included with your range, into both hinge hangers. Do not remove the pins while the door is removed from the range.

3. Tilt top of door toward range. Slide hinge hangers down onto front frame support pins. Make sure the hinge hangers are fully seated and engaged on the support pins.

2. Slowly close the door until it rests against the door removal pins. 3. Grasp the door on the sides with your fingers on the front of the door and your thumbs on the inside surface. 4. Pull door straight up, then toward you. Hinge hangers will slide out of front frame hinge slot. Do not remove door removal pins until the door is replaced on the range.

4. Insert the door stop clip with the angular surface at the top of the frame hinge slot, then push in the bottom of the clip until flanges are flush with the front frame.

5. Open the door completely and remove the door removal pins. Save door removal pins for future use. 6. Close the door.

Storage Drawer
To Replace:
1. Grasp the door on the sides with your fingers on the front of the door and your thumbs on the inside surface. 2. Hold oven door so that the top edge of each hinge hanger is horizontal. Insert hinge hangers into the front frame hinge slots. The storage drawer can be removed. Before removing, make sure drawer is cool and empty.

To Remove:
1. Pull drawer straight out to the first stop. 2. Lift up the back of the drawer and pull out.

To Replace:
1. Fit the ends of the drawer rails into the guides in the cavity. 2. Slide the drawer closed.

TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call. s Is propane gas being used? Nothing will operate The appliance may have been converted improperly. Contact a service technician or see �Assistance or Service� s Is the power supply cord unplugged? section. Plug into a grounded 3 prong outlet.
s

Has a household fuse blown, or has a circuit breaker tripped? Replace the fuse or reset the circuit.

Surface burner makes popping noises
s

Is the burner wet? Let it dry.

Surface burners will not operate Excessive heat around cookware on cooktop
s

Is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines. Is the control knob set correctly? Push in knob before turning to a setting. Are the burner ports clogged? See �Sealed Surface Burners� section.

s

s

Is the cookware the proper size? Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than 1" (2.5 cm) outside the cooking area.

s

Cooktop cooking results not what expected
s

Surface burner flames are uneven, yellow and/or noisy
s

Is the proper cookware being used? See �Cookware� section. Is the control knob set to the proper heat level? See �Cooktop Controls� section. Is the appliance level? Level the appliance. See the Installation Instructions.

Are the burner ports clogged? See �Sealed Surface Burners� section. On models with caps, are the burner caps positioned properly? See �Sealed Surface Burners� section.

s

s

s

14