This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Text excerpt from page 8 (click to view)
Accessories/Options
2
Setting-up
Television unit Lift the television unit above the pedestal base, with the back of the display unit on the same side as the Label. Then align the holes in the television unit with the poles of the pedestal and lower the television unit into place. Use the assembly screws B (M5 x 30) to fasten securely.
* Carry out work on a horizontal and level surface.
B B
Rear Label
Pedestal
3
Stopping the plasma television from falling over
* The plasma TV must be fastened to both the base and the wall.
For 37'', 42'', 50'' Plasma television
Accessories for pedestal security
1 Band (2) 2 Screw (2) 3 Wood screw (2) 4 Clamp (2)
Nominal diameter 4 mm x 12
â� Securing to a base
â� Securing to a wall
* Remove the screws at both top corners on the rear side of the plasma TV, and attach the clamps 4 to the plasma TV using the removed screws.
Front
Screws on main body
Front
Securing method D * Use strong wire or chain which is commercially available to secure the plasma television to a solid area of the wall or a pillar.
Wood Worktop
Fasten with wood screws in the holes in the back edge of the wood worktop. If there are no holes, first drill them in the middle of the thickness of the wood worktop, and then fasten the strap with wood screws.
