|
There are currently no product reviews.
 ;
Excellent manual. In addition to the information I needed was a complete description of both electronic and mechanical devices.
Excellent site.
Thank you very much.
 ;
very good and complete manual , it is in english and german is perfect for repair.
;
This manual is complete and of high quality. I am very pleased with the purchase.
;
Another excellent buy! A fully readable PDF archive. Good prints!!
;
It is wonderful done!!! a great job in scanning the manual. Superior quality in all the electric scheme. Very understandable and net!!! Thank you!
4. LCD panel drive center voltage adjustment (Perform the
adjustment when replacing main PC board or LCD panel)
When inputting video signal data to the LCD panel, center voltage of specified range is adjusted to output symmetrical wave. If this voltage is out of alignment, the LCD panel is damaged by flicker or burning. So it must adjust completely. R, G and B panels should be adjusted for each front projection mode (Front) and Ceiling hunger projection mode (Ceiling). (1) Start signal generate software (SINGO98.exe) and select the Burst signal to output.
(3) Press [R], [G] or [B] key to select the adjustment. When you press the key, it turns ON or OFF. For example, to display red, press [G] and [B].
R-Burst
B-Burst
(2) Right-click to display the Burst submenu, enter [1] in the line interval box and select [V] in the H/ V.
G-Burst
6
|
