|
Who's Online
There currently are 5827 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Thank you very much you are helping me a lot with my preferred hobby!!! this manual of an old TV is going to be very helpful!!!!
You are very honest competent great job very clear and well done!!!!
Matteo
;
An excellent service manual contains dismantling locations of components, electronic adjustments,worth the money.
;
Caracteristiques,circuit adjusment,notes on schematis diagram,it's a good service manual,to live well,thanks.
;
Service Manual in good quality, with all of the pages.
;
Very usrfull for repaur, great quality copy. includes complete parts list and schematics
Wiring Diagram page 5 /8
#299 1) Insert the RED tape side of "ECN" in the T-com board. 2) �ECN" must pass on �ELCD3�. *Refer to photo 1 (page3/4) Do the styling so that the wire After dressing �EPS" and �ELCD3�, stick the tape (#299 Nitto tape) on them. Refer to the Final Assy Guide Page 5/9. should not pass the upper part of ELCD3 EPS the shielding case.
D8MW
Do the styling so that the binding tape of �ELCD3� should not pass over the
frame. (Prevent it from touching with the back-cover.)
#299
#SKUL
#SKUL
Insert it surely.
#SKUL ELCD ELCD2
#361
ECN EPS
UT32S402 UT32S602, UT32V502, UT32V502W, UT32X812, ONLY.
12pin
#360 EFF
Detail-1(page2/4) Photo2(page3/4)
ELS NSPK
EISP
NSP EKL EISP EPU #NSP
EISP NEL E001
E002
The wire of �EKL" must go in between the KEY_SW
Photo 4 (page3/4)
IR/POW SW board
Detail-2
(page2/4)
board and the case, the surplus is hold in between. (It is to prevent the electric wire being pinched when tightening up a screw.) *Refer to photo3(page3/4)
Fix with SK binder(#NSPK) so that the wire of �EISP" should not touch the filter board. *Refer to photo5 (page 4/4)
TABLE OF CONTENTS
40
|
|
|
> |
|