JVC UX-M5R
Owner's Manual

Common Operations
Turning On or Off the Unit
To turn on the unit
Press STANDBY/ON on the unit or remote control. The unit turns on with the last source selection remaining valid.
STANDBY/ON

Continued

STANDBY /ON

or

On clock resetting If a power failure occurs or the AC power cord is disconnected, the clock is reset to "00:00" (flashing). In such a case you need to set the clock again.

Adjusting the Volume
� You can adjust the volume only while the unit is turned on.

To turn off the unit (on standby)
Press STANDBY/ON on the unit or remote control. The clock time appears if the clock is already set.

Setting the Clock
Before operating the unit any further, first set the built-in clock.

Press VOLUME + or VOLUME � to increase or decrease the volume level.
The volume can be adjusted in 41 steps between �VOL MIN� (minimum) and �VOL MAX� (maximum).

VOLUME

1 When the unit is in standby mode, press and hold PROGRAM until the hour indication starts blinking.

PROGRAM

To increase or decrease the volume level rapidly, press and hold VOLUME + or VOLUME �.

To turn off the sound temporarily
Press MUTING on the remote control.
MUTING

� When the unit is on, press DISPLAY MODE to enter clock mode, then press and hold PROGRAM.

Playback continues without sound and �MUTING� appears on the display. To restore the sound, press MUTING again or increase or decrease the volume level. For private listening Connect a pair of headphones to the PHONES jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on headphones.
DO NOT turn off the unit (on standby) with the volume set to an extremely high level; otherwise, a sudden blast of sound can damage your hearing and/or the speakers when you turn on the unit or start playing any source next time.

2 Press 4 or ¢ to set the hour, then press PROGRAM.
The minute indication starts blinking.

SEARCH/TUNING

3 Press 4 or ¢ to set the minute, then press PROGRAM to store the setting.
The clock starts working.

SEARCH/TUNING

To change the hour or minute indication rapidly in steps 2 and 3, press and hold 4 or ¢.

To select 12-hour or 24-hour display mode
In standby mode, hold down 7 and press PROGRAM on the unit repeatedly. With each press, the selection toggles between 12-hour and 24hour modes. � In 12-hour mode, �AM 12:00� indicates midnight and �PM 12:00� indicates noon.
STOP/CLEAR

PROGRAM

and

To check the clock time while the unit is on
Press DISPLAY MODE. The clock time is displayed until you press any key.
DISPLAY MODE

To correct the clock time
Carry out steps 1 to 3 above.

�8�