|
Who's Online
There currently are 5918 guests and 14 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
VL-NZ50S/H/E/W/NZ80H VL-NZ100S/H/E 5. 7.
(i) (c) Microphone Cover Camera Front Cabinet (c) (o)
Mechanism
NZ50S/H/E/W
(i) (i) NZ80H/NZ100S/H/E
(i)
(i) (i)
(i)
(k)
(c)
(k)
(h)
(k)
(c)
Camera Rear Cabinet
Camera Rear Cabinet (c)
(m)
1) Take the mechanism out. 2) Remove the 3 floating screws A ((k)LX-BZ0251TAFD) and 1 floating screw B ((m)LX-BZ0253TAFN).
6.
1) Remove the 3 screws ((c)XiPSN17P03000), 4 screws ((i)XiPSF17P03000) and 1 screw ((h)XiPSF17P02000) (NZ50S/H/E/W only) fixing the camera rear cabinet to detach it. (Note: When detaching the camera rear cabinet, pay attention to the FPC of the camera operation unit.) 2) Remove the 2 screws ((i)XiPSF17P03000) and detach the camera side cover in the direction of the arrow. (Note: When detaching the side cover, pat attention to the lead wire of the speaker.) 3) Remove the 1 screw ((i)XiPSF17P03000) and 1 screw ((o)XiPSN17P06000) and detach the microphone cover in the direction of the arrow. (Note: When detaching the microphone cover, pay attention to the lead wire of the microphone.) 4) Remove the 2 screws ((c)XiPSN17P03000) and camera front cabinet.
8.
Lithium Holder
(r) (r) Lithium PWB Unit
(c) (c) Power SW Unit
1) Remove the lithium holder and 2 screws ((r)XiPSN17P04000) to detach the lithium PWB unit.
1) Remove the 1 screw ((c)XiPSN17P03000) to detach the power SW unit. (Note: When detaching the power SW unit, pay attention to the FPC.) 2) Remove the 1 screw ((c)XiPSN17P03000) to detach the lens unit.
5
|
|
|
> |
|