|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Easy to access. Clear instructions. No problems. Printed fine.
 ;
Great scan but please note that it is entirely in GERMAN.
;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
Preparations
Dynamic range control setting mode
Dynamic range is the difference between the loudest and softest sounds in any given signal. The dynamic range control helps you play back sounds so the quieter sounds are audible yet the louder sounds don�t get distorted. It does this by compressing the dynamic range. When watching a movie at low volume, setting this function enables you to hear low level sounds to more easily but you won�t be jolted by lounder sounds.
� Initial setting is �OFF�. � When the volume level is increased, set to �OFF�. � For listening enjoyment at low volumes, set to �MAX� for maximum dynamic range compression. � Dynamic range control is effective only when a Dolby Digital signal is being played back.
dB
Press % or � to set the dynamic range control (OFF, MAX, or MID).
Dual mono setting mode
The dual mono setting can only be used when listening to Dolby Digital discs that contain a dual mono soundtrack. With this setting you can choose which channel is the dual mono setting you want to listen to. Thus, it is useful for soundtracks that have one language on one channel and a different language on the other. Remember you can only use this setting if you have Dolbly Digital software with this feature and want to isolate one of the channels therein. There are two different ways to route the sound in the dual mono setting, one is with Dolby Digital mode on, the other with Dolby Digital mode off. If Dolby Digital mode is switched on, the ch1 setting will play channel 1 through your center speaker. The ch2 setting will play channel 2 though your center speaker and the MIX setting will play both channels through the center speaker. With Dolby Digital mode off, the dual mono sound routing is as follows: In the ch1 setting your will hear channel 1 out of both front speakers. In the ch2 setting you will hear channel 2 out of both speakers. In the L. c1 R. c2 setting the speakers will play the soundtrack independently of each other. The left front speaker will play channel 1 and the right front speaker will play channel 2. The last setting, MIX, mixes both channels and plays them out of both speakers .
� The default setting of this feature is L. c1 R. c2.
L. c 1 R. c 2 MIX ch2 ch1
Press % or � to cycle through the possible Dual mono settings.
Set up
Coaxial digital input setting
Sets the input component to be assigned to the COAX (coaxial) digital input jack.
� Initial setting is �DVD�.
dB
Press % or � to select the coaxial digital input (DVD, TV, CD, CD-R, VCR, DVR or OFF).
After you assign the component to the COAX digital jack, when you select that component, for example DVD, the receiver will automatically change to the digital input setting. You can see this in the DIGITAL/ANALOG indicator on the front of the receiver.
19
En
|
|
|
> |
|
