|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Exactly what I needed to be able to bring the amp back to life... will come back to this site the next time I need schematics.
;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
 ;
Very very good as usual very trustable site. Perfect!!!!!!
;
The Service Manual received was helpful. Good copy of original document.. I recomend all of my friends about this technical page.
;
Perfect, complete manual, exactly what I needed. Recommended to everyone.
5. Alignment and Adjustment
5-1 Reference
1) X-Point (Tracking center) adjustment, �Head switching adjustment� and �NVRAM option setting� can be adjusted with remote control. 2) When replacing the micom (IC601) be sure to adjust the �Head switching adjustment� and �NVRAM option setting�. 3) When replacing the cylinder ass�y, be sure to adjust the �X-Point� and �Head switching adjustment�. 4) Remote control used for same chassis as a accessory is available for all adjustments. 5) How to adjustment. - Intermittently short-circuit the test point on Main PCB with pincets to set the adjustment mode. - If the corresponding adjustment button is pressed, the adjustment is preformed automatically. - If the adjustment is completed, be sure to turn the power off.
5-1-1 Location of adjustment button of remote control
VCR
TV
POWER
1
2 5 8 0
3
CH/TRK
X-Point (Tracking Center) Adjustment
4 7
I.SELECT
6 9
TV VOL
100
COUNT RESET TV/VCR
DISPLAY
REMAIN/ COUNTER
SP/SLP
REC
TIMER
Head Switching Adjustment
PLAY
REW
CURSOR
FF
SLOW
STOP
PAUSE/STILL
PROG.
CANCEL
ENTER
NVRAM Option Setting
A.SELECT EJECT
VC-602
Fig. 5-1 Toshiba 5-1
|
|
|
> |
|
|
Parse Time: 0.16 - Number of Queries: 127 - Query Time: 0.038
