Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
Text excerpt from page 16 (click to view)
INSTALLATION INSTRUCTIONS
INSTALLATION
� � Install the appliance on a solid and level floor surface, preferably in a corner of the room. Make sure that all four feet are stable and resting on the floor and then check that the appliance is perfectly level (use a spirit level). If the floor is uneven, adjust the levelling feet as required (do not insert pieces of wood etc. under the feet):
�
1. Slacken the locknut using the spanner supplied. 2. Adjust the height of the foot, turning it by hand. 3. Tighten the locknut by turning it anti-clockwise towards the appliance casing. � If the appliance is to be installed on a wooden floor, distribute the weight by placing it on a 60 x 60 cm sheet of plywood at least 3 cm in thickness. Secure the plywood sheet to the floor.
WORKTOP / COVER PANEL
The appliance must only be installed beneath a continuous fitted kitchen worktop. If the appliance will be built under it is mandatory to use the cover panel UBS. This can be obtained from specialist shops or from After-Sales Service. � Unplug the appliance. 1. Unscrew the worktop fixing screws from the rear of the appliance. 2. Slide the worktop fully backward and lift it upwards to remove. Install the cover panel following the relative instructions. 3. Refit the fixing screws and tighten them.
BUILD-UNDER OPENING DIMENSIONS
Width Height Depth 600 mm 825 mm 600 mm
WARNING: Only plug the appliance into the mains power socket after you have fitted the cover panel or the appliance worktop.
