BAUKNECHT WA 7760-D
Quick Start

GB Overview of consumption data
Programme Duration Programme approx. (hour : minutes)

Temperature Max. Load Water Energy �Rinse Hold� button (°C) (kg) (l) (kWh) � The laundry remains in last rinse water without progressing the final spin cycle to avoid

Cotton 95 5.0 44* 1.60 1 : 55

creasing and prevent colours from changing. � This option is particularly recommended for the programme �Synthetics� or �Delicates�.

Coloured Cotton 60 5.0 39 0.95 2 : 00 � This function is particularly useful if you want postpone spinning to a later time.

Coloured Cotton + Rapid 30 3.0 32 0.40 0 : 50

Note: The programme stops to at time the �Rinse Hold� button light flashes. Coloured Cotton 40 5.0 39 0.55 1 : 45 Terminate the �Rinse Hold� option: � Press �Rinse Hold� button again; programme will terminate automatically with the final � If you do not wish spin clothes, turn selector knob to the drain programme Synthetics 40 2.5 50 0.50 1 : 15 and press the �Start/Pause� button again.

Synthetics 60 2.5 55 0.70 1 : 30 spin cycle for the present wash programme.

Programme 3.0 35 0.40 0 : 30 �Spin Speed Reduction� button

Delicates 30 1.5 50 0.50 0 : 45

� Every programme has an automatic predefined maximum spin speed. � Press the button to set another spin speed.

Wool 1.0 50 0.50 0 : 40 � If spin speed �0� selected, the final spinning cancelled. The water is drained out only.

Handwash cold 1.0 0.20 0 : 35 PROGRAMME START

Open tap and press button. The pilot lamp of the �Start/Pause� button lights Prewash cycle increases programme duration by approximately 15 min. Consumption values were measured in up. The indicator lamps show sequence reached in programme. After starting the programme, normalized conditions in compliance with Standard IEC 60 456. The data on the �Energy Label� refer to programme

�Coloured Cotton 60 °C�. Consumption data home may vary with respect values table in relation indication runs from left to right through Wash, Rinse, Spin. When sequence of the water supply pressure temperature, load and type of wash. programme is finished the corresponding lamp goes out. * To reduce temperature, some cold water is added at end of the main wash cycle, before

DOOR LOCK pump drains the water out. ADD DETERGENT, CLOSE DOOR AND SELECT THE PROGRAMME During first 15 minutes of cotton and synthetics programmes the door can be opened for adding
further laundry. This not possible if �Rapid Wash� is selected. The door can be opened when the �Door Free� indication is shining.

Add detergent as described chapter �Detergent and Additives� in the booklet. 1. Turn selector knob to the desired programme and temperature.

PROGRAMME END � The pilot lamp of the �Start/Pause� button is flashing.
A short audible tone sounds three times. selected programme lights up. 1. Turn programme selector to the � � position. PRESS ANY DESIRED OPTION BUTTON(S). The pilot lamp lights up. 3. Open door and unload the machine. is not possible. Unsuitable combinations of options are deselected automatically.

2. The and predefined spin speed corresponding to � All lights of the programme sequence indication are off.

An audible tone sounds if the combination of programme, additional options and temperature 2. Turn the water supply tap off.

�Eco Wash� button CHANGE THE AND OPTIONS AFTER PROGRAMME START � duration wash is extended and temperature reduced save up 40% of energy 1. Press �Start/Pause� button to pause the programme. The light flashes. maintaining good washing results. 2. Select the new programme, any options and another spin speed if you want it. �Rapid Wash� 3. Press �Start/Pause� button again. The new programme continues at the same position where � For quick, economical washes. Ideal minimum loads of lightly-soiled articles. the previous programme was interrupted. Do not add detergent for this programme. �Prewash� button TO CANCEL A PROGRAMME BEFORE THE END � Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle time increases 1. Press �Start/Pause� button to pause the programme. The light flashes. by approximately 15 min. 2. Set the programme selector to �Drain�. The spin indicators show �0�. �Intensive Rinse� button 3. Press �Start/Pause� button to start the drain programme. � A further rinse cycle is added. � This option is particularly suitable for areas with very soft water washing baby linen and helps people with allergies.