|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good manual. Plenty of service information including alignment instructions. Clear circuit diagram. Excellent, thank you.
 ;
Good morning, the service manual you sent me was perfect.
Your service and answering are excellent.
I recomend this service.
Best regards.
;
I had been looking everywhere for a proper service manual for this VCR. Everywhere else that has this available for download has a very light version. This is the full service manual with all aspects that would interest anyone looking for the service manual for the AIWA HV-MX100 Worldwide VHS VCR. Great quality (as always). A winner hands down. Best Quality.
;
Top quality manual. Covers all aspects you'd expect in a top quality service manual for this Panasonic VHS VCR. The manual resolution is high. Another top quality manual from the only site worth downloading manuals from! If you're looking for a manual for the PV-9662 VHS VCR, this is the one you'll want to get!
;
complete part-lists and pcb layout, schematic diagram is good enlargable,
ADJUSTMENT PROCEDURE
1. Test Equipment Required
The following Test Equipments are required for adjustment of the Digital AV Mixer WJ-AVE55.
Oscilloscope Frequency Counter Digital Voltmeter Vectorscope Waveform Monitor Underscanned Colour Video Monitor Video Signal Generator Audio Generator Extension Board (Part Number: YWV01034AN) for Power Board and Main Board as shown Fig. 1-1.
Disconnect the flat cable. Remove five screws. Remove five screws.
Fig. 2-2 Referring to Fig. 2-3, connect the Extension Board between CN3 on the Power Board and CN3 on the Main Board.
Fig. 1-1
2. Disassembling Procedure for Adjustment
Referring to Fig. 2-1, remove nine screws that secure the Upper Cover and remove the Upper Cover.
Connect the Extension Board.
Fig. 2-3
Remove nine screws.
Fig. 2-1 Referring to Fig. 2-2, remove five screws that secure the Shield Cover and remove the Shield Cover. Disconnect the Flat Cable from CN3 on the Power Board and CN3 on the Main Board. Remove five screws that secure the Main Board and remove the Main Board.
27
|
|
|
> |
|
