perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Super nice! Good to have a manual in digital format.
Text excerpt from page 8 (click to view)
WM60 TRANSMITTER
Front Panel . Sig/Clip Indicator� the LED indicator will light up green when a signal is being received by the WM60 transmitter. It will turn red when the signal level becomes excessive, just 4dB before clipping. . Channel Selector� adjusting this dial to one of the preset channels allows the WM60 to know which frequency to send the wireless information at. The wireless receiver should be set to the identical channel if transmission is to occur successfully. 3. On/Off Button� this button turns the WM60 on and off. 4. Antenna� this is the WM60�s antenna. Adjust it so it sits in a vertical position when the device is in use (change the position if the wireless signal quality is poor). Push the antenna in to release it before adjusting its position. Rear Panel 5. 1/4� Input� this jack accepts balanced and unbalanced /4� inputs from line-level sources. 6. XLR Input� this jack accepts balanced XLR inputs from line-level sources. Both the /4� jack and the XLR jack run in parallel. 7. DC In� plug DC end of the supplied DC power adaptor into this jack, and the other end into a suitable AC power source to allow the WM60 to be powered. Please ensure you use the DC power supply (V, 750mA) provided with this unit, as using another power supply could cause damage.
